• 12336 Emerson Dr, Brighton, MI 48116

Foundry Adhesive 9612

FoundryGeneral® Foundry Adhesive 9612 is a ready to use vegetable oil based hot shell core and mold paste.


Product Description

FoundryGeneral® Foundry Adhesive 9612 is a ready to use vegetable oil based hot shell core and mold paste.

A foundry can lower emissions and meet environmental regulations by reducing the petroleum content.

When applied to the hot drag of a shell mold, FoundryGeneral® Foundry Adhesive 9612 does not boil or dry out quickly, allowing the operator sufficient time to properly position the hot cope half of the mold. After 45 seconds of curing under pressure in the mold press, FoundryGeneral® Foundry Adhesive 9612 develops an extra strong bond which eliminates metal run outs at the parting line and provides casting dimensional accuracy across the parting line.

A solvent-based product designed to meet the increasing demands for higher production rates and efficiency. The product exhibits excellent strength with short periods of set time.

TYPICAL PROPERTIES: Environmental Friendly Foundry Adhesive
Appearance: Thick, yellow to orange paste
Viscosity: 1o,000 cps
Flash Point: 428°F
Density: 8.14 lbs/gal
VOC: Not determine
pH: NA

FoundryGeneral® Foundry Adhesive 9612 may have a slight separation when received. Mechanical agitation is required to thoroughly remix the paste to a uniform consistency. Five minutes when first put into service and one minute at the start of each shift is recommended

Application of FoundryGeneral® Foundry Adhesive 9612 can be done through a normal foundry type paste bulb or by liquid paste pump. Another application 9612 dispensing the liquid from the liquid applicator by a wiper blade traveling over a perforated template. FoundryGeneral® Foundry Adhesive 9612 can also be accurately printed onto the shell by an appropriately contoured fixture with or without a vibrator. Please refer to the MSDS for proper safety instructions.

Ready to use
Vegetable oil based
Low smoke evolution
Extra strong bond
Reduces metal run out during pouring shells

Avoid heat, sparks and open flames. Avoid strong oxidizing agents (i.e. bleach).

FoundryGeneral® Foundry Adhesive 300 is shipped in plastic pails and metal drums.

Note: The information presented herein is our interpretation of certain test results and field experience to date. The information is not to be taken as warranty or representation for which we assume legal responsibility, nor as permission or recommendation to practice any patented invention without a license. It is offered solely for your consideration, investigation and verification.


There are no reviews yet.

Be the first to review “Foundry Adhesive 9612”